Fagor CNC 8065 - Data Programming

·148·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for the axes. Work sets.
DECEL to the movements in G1, G2 and G3; movements in G0 depend on parameter
G0ACDCJERK.
ACCJERKG0
Acceleration jerk (G0 movements).
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 1.0000 a 1000000000.0000 mm/s³ or degrees/s³ / from 0.03937 to
39370078.74016 inch/s³.
Default value: 10000.000 mm/s³ or degrees/s³ / 393.70087 inch/s³.
Associated variable: (V.)[ch].MPA.ACCJERKG0[set].xn
See machine parameter DECJERKG0.
DECJERKG0
Deceleration jerk (G0 movements).
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 1.0000 a 1000000000.0000 mm/s³ or degrees/s³ / from 0.03937 to
39370078.74016 inch/s³.
Default value: 10000.000 mm/s³ or degrees/s³ / 393.70087 inch/s³.
Associated variable: (V.)[ch].MPA.DECJERKG0[set].xn
Parameters ACCJERKG0 and DECJERKG0 set the slope of the acceleration and
deceleration. Both parameters help limit the acceleration changes so the machine runs more
smoothly in small speed increments or decrements and with FFGAIN values close to 100%.
The lower the value assigned to these parameters, the smoother the machine response, but
the acc/dec time will increase.
The CNC applies parameters ACCEL and DECEL to the movements in G1, G2 and G3;
movements in G0 depend on parameter G0ACDCJERK. The CNC ignores these parameters
in threading movements (G33) and with HSC FAST.
CONFIGURATION OF THE HSC MODE.
HSC
Parameter table of the HSC mode..
This parameter shows the table to define the HSC work mode.
These parameters help increase or decrease the acceleration and jerk limits on curved path,
due to the centripetal acceleration and at path joints, without affecting the way the axis
accelerates or decelerates.
G0ACDCJERK Meaning.
Yes. Movements in G0 use parameters ACCELG0 and DECELG0.
No. Movements in G0 use parameters ACCEL and DECEL.
G0ACDCJERK Meaning.
Yes. Movements in G0 use parameters ACCJERKG0 and DECJERKG0.
No. Movements in G0 use parameters ACCJERK and DECJERK.
HSC
CORNERACC Maximum acceleration permitted at the corners.
CURVACC Maximum contouring acceleration permitted.
CORNERJERK Maximum Jerk permitted at the corners.
CURVJERK Maximum contouring Jerk permitted.
FASTACC Maximum acceleration permitted (FAST mode).
MAXERROR Position error.
CONTERROR Tolerance per axis.