Fagor CNC 8065 - PLC Consulting Logic Signals; General

·690·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC consulting logic signals; general.
10.14 PLC consulting logic signals; general.
(V.)PLC.CNCREADY
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The CNC activates the mark when it is not in an error state.
(V.)PLC.READY
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates the mark when it is not in an error state.
(V.)PLC.SERCOSRDY
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The CNC activates the mark when the Sercos ring has been initialized properly.
(V.)PLC.START
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The channel activates this mark when the [START] key has been pressed.
(V.)PLC.RESETOUT
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
When pressing the [RESET] key or when the PLC activates the RESETIN mark, the CNC
assumes the initial conditions and activates the RESETOUT mark.
V.PLC.CNCREADY
V.PLC.READYC1 Channel ·1·.
V.PLC.READYC2 Channel ·2·.
V.PLC.READYC3 Channel ·3·.
V.PLC.READYC4 Channel ·4·.
V.PLC.SERCOSRDY
V.PLC.START Channel ·1·.
V.PLC.STARTC1 Channel ·1·.
V.PLC.STARTC2 Channel ·2·.
V.PLC.STARTC3 Channel ·3·.
V.PLC.STARTC4 Channel ·4·.
V.PLC.RESETOUT Channel ·1·.
V.PLC.RESETOUTC1 Channel ·1·.
V.PLC.RESETOUTC2 Channel ·2·.
V.PLC.RESETOUTC3 Channel ·3·.
V.PLC.RESETOUTC4 Channel ·4·.