Fagor CNC 8065 - Variables Related to Jog Mode

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·839·
Variables related to jog mode.
10.52 Variables related to jog mode.
MOVEMENT ALLOWED IN JOG MODE.
(V.)[ch].G.INTMAN
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Movements in jog mode are allowed.
Syntax.
·ch· Channel number.
Remarks.
Jog movements are allowed when the jog mode or the TEACH-IN mode is active, during tool
inspection and when functions G200 and G201 are active.
TYPE OF MOVEMENT ACTIVE IN THE CHANNEL.
(V.)G.MANMODE
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Type of movement active for all the axes.
Values of the variable.
This variable returns one of the following values.
Remarks.
The type of movement may be set by the switch of the operator panel or by PLC; the one
set by PLC has the highest priority.
(V.)G.CNCMANMODE
Variable that can be read and written from the interface and read from the program and from the PLC.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Type of movement selected at the switch for all the axes.
The value set by the switch of the operator panel has lower priority than the one set by PLC.
V.[2].G.INTMAN Channel ·2·.
V.G.MANMODE
Value. Meaning.
1 Handwheel mode.
2 Continuous jog mode.
3 Incremental jog mode.
V.G.CNCMANMODE