Fagor CNC 8065 - Variables Related to the Sets of Machine Parameters

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·617·
Variables related to the sets of machine parameters.
10.7 Variables related to the sets of machine parameters.
FEEDBACK RESOLUTION.
(V.)[ch].MPA.PITCH[set].xn
(V.)[ch].MPA.PITCH[set].sn
(V.)[ch].SP.PITCH[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the execution value; reading it interrupts block preparation.
Leadscrew pitch.
Depending on the type of feedback, this parameter means the following.
• On a linear axis with a rotary encoder and leadscrew, it defines the leadscrew pitch.
• On a linear axis with a linear encoder (scale), it defines the pitch of the scale.
• On a rotary axis, it sets the number of degrees per turn of the encoder.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
(V.)[ch].MPA.INPUTREV[set].xn
(V.)[ch].MPA.INPUTREV[set].sn
(V.)[ch].SP.INPUTREV[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the execution value; reading it interrupts block preparation.
Gear ratio; turns of the motor shaft.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
V.MPA.PITCH[3].Z Z axis.
V.MPA.PITCH[3].S Spindle S.
V.SP.PITCH[3].S Spindle S.
V.SP.PITCH[3] Master spindle.
V.MPA.PITCH[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.PITCH[3].1 Axis with index ·1· in the channel ·2·.
V.SP.PITCH[3].2 Spindle with index ·2· in the system.
V.[2].SP.PITCH[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA.INPUTREV[3].Z Z axis.
V.MPA.INPUTREV[3].S Spindle S.
V.SP.INPUTREV[3].S Spindle S.
V.SP.INPUTREV[3] Master spindle.
V.MPA.INPUTREV[3].4 Axis or spindle with logic number ·4·.