Fagor CNC 8065 - PLC Modifiable Logic Signals; Spindles

·728·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC modifiable logic signals; spindles.
10.22 PLC modifiable logic signals; spindles.
(V.)PLC.GEAR1
(V.)PLC.GEAR2
(V.)PLC.GEAR3
(V.)PLC.GEAR4
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn on the mark corresponding to the selected speed range.
There is a mark for each spindle. The mnemonics for each channel are the following. Here
is an example of the mnemonics for GEAR1; it is the same for the rest of the registers.
(V.)PLC.PLCCNTL
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on when the spindle is controlled by the PLC.
(V.)PLC.SANALOG
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
When the spindle is controlled by the PLC, the PLC must indicate in this register the velocity
command to be applied to the spindle.
(V.)PLC.SPDLEREV
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the CNC inverts the spindle turning direction.
V.PLC.GEAR1 Spindle ·1·.
V.PLC.GEAR1SP1 Spindle ·1·.
V.PLC.GEAR1SP2 Spindle ·2·.
V.PLC.GEAR1SP3 Spindle ·3·.
V.PLC.GEAR1SP4 Spindle ·4·.
V.PLC.PLCCNTL Spindle ·1·.
V.PLC.PLCCNTL1 Spindle ·1·.
V.PLC.PLCCNTL2 Spindle ·2·.
V.PLC.PLCCNTL3 Spindle ·3·.
V.PLC.PLCCNTL4 Spindle ·4·.
V.PLC.SANALOG Spindle ·1·.
V.PLC.SANALOG1 Spindle ·1·.
V.PLC.SANALOG2 Spindle ·2·.
V.PLC.SANALOG3 Spindle ·3·.
V.PLC.SANALOG4 Spindle ·4·.
V.PLC.SPDLEREV Spindle ·1·.
V.PLC.SPDLEREV1 Spindle ·1·.
V.PLC.SPDLEREV2 Spindle ·2·.
V.PLC.SPDLEREV3 Spindle ·3·.
V.PLC.SPDLEREV4 Spindle ·4·.