·352·
Installation manual
CNC 8060
CNC 8065
7.
TOOL AND MAGAZINE MANAGEMENT.
(REF: 1402)
Variables related to tool magazine management.
7.4 Variables related to tool magazine management.
The variables associated with the magazine that are involved in the tool magazine
management are the following. There is one group of variables for each channel. Replace
the [n] character with the channel number, maintaining the brackets.
V.[n].TM.MZMODE
Operating mode of the tool magazine manager.
V.[n].TM.MZSTATUS
Tool manager status.
V.[n].TM.MZRUN
Tool manager running.
V.[n].TM.MZWAIT
Tool manager executing a maneuver. It indicates whether to wait or not for the maneuver to
end.
There is no need to program it in the subroutine associated with M06. The subroutine itself
waits for the manager's maneuvers to finish. This way, block preparation is not interrupted.
With a ·0· value Normal mode (by default and after reset).
With a ·1· value Magazine loading mode.
With a ·2· value Magazine unloading mode.
With a ·0· value Normal.
With a ·1· value An error has occurred.
With a ·2· value An error has occurred; but it will wait for the current maneuver
to be completed.
With a ·4· value Emergency.
With a ·0· value There is no sequence in execution.
With a ·1· value There is a sequence in execution.
With a ·0· value No need to wait.
With a ·1· value It has to wait.
To Next Page
Loading...
