Fagor CNC 8065 - Variables Associated with any Tool

·822·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables associated with any tool.
10.50 Variables associated with any tool.
The variables referred to a tool other than the active one are for synchronous reading if the
tool is in the magazine and for asynchronous reading if otherwise. The writing of these
variables is always asynchronous, be it for the active tool or not.
TOOL STATUS.
(V.)TM.TSTATUST[tl]
Variable that can be read from the PLC and from the interface.
Tool [tl]. Tool status.
Syntax.
·tl· Tool number.
Values of the variable.
This variable returns one of the following values.
FAMILY OF THE TOOL.
(V.)TM.TLFFT[tl]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
Tool [tl]. Family code.
Syntax.
·tl· Tool number.
TOOL MONITORING.
(V.)TM.TOMONT[tl][ofd]
Variable that can be read and written via program, PLC(asynchronous writing) and interface.
The variable returns the execution value; reading it interrupts block preparation.
[odf] offset of the [tl] tool. Type of tool life monitoring.
Syntax.
·tl· Tool number.
·ofd· Tool offset.
Value. Meaning.
0 Tool available.
1 Tool available.
2 Tool worn out.
V.TM.TLFFT[23] Tool ·23·.
V.TM.TOMONT[23][3] Tool ·23·. Tool offset ·3·.