Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·821·
Variables related to the active tool and to the next one.
CANCEL THE PRESET TURNING DIRECTION OF THE TOOL.
(V.)G.SPDLTURDIR
Variable that can be read and written from the program and read from the PLC (asynchronous) and from
the interface.
The variable returns the execution value; reading it interrupts block preparation.
Modify the preset turning direction for the active tool.
The preset turning speed of the active tool may be temporarily canceled from the part-
program. This is done by setting this variable to ·0·. The variable does not modify the tool
table. When changing a tool, this variable will take the corresponding value according to what
has been set in the tool table.
Values of the variable.
This variable returns one of the following values.
Value. Meaning.
0 Without preset turning direction.
1 Turning direction M03.
2 Turning direction M04.
To Next Page
Loading...
