Fagor CNC 8065 - Page 727

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·727·
PLC modifiable logic signals; axes and spindles.
Syntax.
·xn· Name or logic number of the axis.
·sn· Name or logic number of the spindle.
(V.)PLC.SWITCHxn
(V.)PLC.SWITCHsn
Variable that can be read and written from the program and interface and read from the PLC.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
When the system has multi-axis groups, this mark may be used to toggle between the various
axes or spindles of the group.
Syntax.
·xn· Name or logic number of the axis.
·sn· Name or logic number of the spindle.
(V.)PLC.TANDEMOFFxn
(V.)PLC.TANDEMOFFsn
Variable that can be read and written from the program and interface and read from the PLC.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
This mark may be used to temporarily decouple (unslave) the loop of the axes or spindles
involved in the tandem so they can be move separately.
Syntax.
·xn· Name or logic number of the axis.
·sn· Name or logic number of the spindle.
V.PLC.DEADX X axis.
V.PLC.DEADS Spindle S.
V.PLC.DEAD3 Axis or spindle with logic number ·3·.
V.PLC.SWITCHX X axis.
V.PLC.SWITCHS Spindle S.
V.PLC.SWITCH3 Axis or spindle with logic number ·3·.
V.PLC.TANDEMOFFX X axis.
V.PLC.TANDEMOFFS Spindle S.
V.PLC.TANDEMOFF3 Axis or spindle with logic number ·3·.