·840·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to jog mode.
Values of the variable.
This variable returns one of the following values.
(V.)PLC.MANMODE
Variable that can be read and written from the PLC and read from the program and from the interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Type of movement selected by PLC for all the axes.
The value selected by PLC prevails over the one selected on the operator panel. To cancel
the feedrate set by PLC, set the variable to ·0·.
Values of the variable.
This variable returns one of the following values.
TYPE OF MOVEMENT ACTIVE ON AN AXIS.
(V.)[ch].A.MANMODE.xn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Type of movement active for all the ·xn· axis.
Syntax.
·ch· Channel number.
·xn· Name, logic number or index of the axis.
Values of the variable.
This variable returns one of the following values.
Value. Meaning.
1 Handwheel mode.
2 Continuous jog mode.
3 Incremental jog mode.
V.PLC.MANMODE
Value. Meaning.
0 Nothing has been selected by PLC.
1 Handwheel mode.
2 Continuous jog mode.
3 Incremental jog mode.
V.A.MANMODE.Z Z axis.
V.A.MANMODE.4 Axis with logic number ·4·.
V.[2].A.MANMODE.1 Axis with index ·1· in the channel ·2·.
Value. Meaning.
1 Handwheel mode.
2 Continuous jog mode.
3 Incremental jog mode.
4 Handwheel mode without selected axis. The handwheel
mode has been selected but the axis to be moved has not
been selected.
To Next Page
Loading...
