·156·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for the axes. Work sets.
INPOTIME
Minimum time to stay in position.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 1000000 ms.
Default value: 0.
Associated variable: (V.)[ch].MPA.MPA.INPOTIME[set].xn
Parameter INPOTIME sets the time the axis must stay in the in-position zone so the CNC
considers it to be "in position".
Parameters INPOMAX and INPOTIME ensure that when working with dead axes (axes only
controlled while moving), the movement will be completed when they are in position.
AXIS LUBRICATION.
DISTLUBRI
Distance to move to lubricate the axis.
Parameter valid for linear and rotary axes and spindles.
Parameter valid for analog drive, Sercos and simulated.
Possible values: From 0 to 2000000000 mm or degrees / from 0 to 78739920 inch.
Default value: 0 (no lubrication).
Associated variable: (V.)[ch].MPA.DISTLUBRI[set].xn
The PLC reads this parameter in mm instead of doing it in tenths of a micron (0.0001 mm).
The lubrication signal is activated after travelling the distance indicated in this parameter.
The CNC logic inputs and outputs: LUBR(axis), LUBRENA(axis) and LUBROK(axis) must
be used in order for the PLC lubricates the axes and gears.
1 The LUBRENA(axis) mark indicates whether this feature is to be used or not.
2 When the axis has traveled the distance set by parameter DISTLUBRI, the CNC turns
the LUBR(axis) mark on to let the PLC know that it must lubricate the axis.
3 After lubricating the axis, the PLC sets the LUBROK(axis) mark high (=1) to let the CNC
know that the axis has been lubricated.
4 The CNC sets the LUBR(axis) mark low (=0) and resets its count to "0".
MODULE CONFIGURATION (ROTARY AXES AND SPINDLE).
MODUPLIM
Upper limit of the module.
Parameter valid for rotary axes and spindles.
Parameter valid for analog drives, velocity-Sercos drives and simulated drives.
Possible values: Within ±99999.9999º.
Default value: 360.
Associated variable: (V.)[ch].MPA.MODUPLIM[set].xn
See machine parameter MODLOWLIM.
MODLOWLIM
Lower limit of the module.
Parameter valid for rotary axes and spindles.
Parameter valid for analog drives, velocity-Sercos drives and simulated drives.
Possible values: Within ±99999.9999º.
Default value: 0.
Associated variable: (V.)[ch].MPA.MODLOWLIM[set].xn
The CNC takes these parameters into consideration only when AXISMODE = Module.
For a reading within ±180°, set MODUPLIM = 180º and MODLOWLIM = -180º.
To Next Page
Loading...
