Fagor CNC 8065 - Page 190

·190·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Machine parameters for kinetics.
TDATA10
Turning direction of the main rotary axis.
Possible values: 0 (by the standard DIN 66217) / 1 / opposite to the standard DIN 66217).
Default value: 0.
See parameter TDATA11.
TDATA11
Turning direction of the secondary rotary axis.
Possible values: 0 (by the standard DIN 66217) / 1 / opposite to the standard DIN 66217).
Default value: 0.
The direction of the XYZ axes, according to the DIN 66217 standard is easy to remember
using the rule of the right hand. On rotary axes, the turning direction is established when
bending your fingers (closing your hand) around the associated linear axis while your thumb
is pointing in the positive direction of the linear axis. On kinematics with rotary axes on the
table, the turning direction is set from the point of view of the tool; therefore, TDATA10 and
TDATA11 must be set to 1.
TYPE=13
X
Y
Z
A
B
DATA 1(+)
Y
Z
DATA 3(+)
DATA 14(+)DATA 13(+)
X
Z
DATA 4(+)
DATA 15(+)
DATA 6(+)
XY
Z
B
DATA11 = 0
DATA11 = 1