Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·207·
Machine parameters for the magazine.
The tool change is carried out as follows: Example with 2 holders:
1 The new tool is selected in the magazine.
2 It ends the movement of the axes.
3 The arm takes a tool on each holder (from the magazine and from the spindle) and swaps
them.
4 The arm retracts.
5 The CNC resumes program execution.
Asynchronous magazines.
An asynchronous magazine is located away from the spindle. Most of the movements may
be carried out while machining the part, thus minimizing machining time.
The tool change is carried out as follows:
1 While machining, a new tool is selected at the magazine, the changer arm picks it up and
brings it closer to the spindle.
2 It ends the movement of the axes.
3 The other holder picks up the tool that is in the spindle and makes the change.
4 The program resumes execution and the changer arm returns to the magazine to leave
the tool.
To Next Page
Loading...
