Installation manual
CNC 8060
CNC 8065
PLC PROGRAMMING.
4.
(REF: 1402)
·267·
Action instructions.
Gear ratio.
Ratio (Nslave/Nmaster) between the number of turns of the slave axis (Nslave) and the
number of turns of the master axis (Nmaster).
The gear ratio is determined when programming the instruction and its value remains
constant during the whole operation. In this synchronization mode, it is not possible to
change this value while the system is running, because this behavior is more for an electronic
cam than for an electronic gear. To solve this matter, an electronic cam may be programmed
instead.
To Next Page
Loading...
