Installation manual
CNC 8060
CNC 8065
LOGIC CNC INPUTS AND OUTPUTS.
6.
(REF: 1402)
·303·
Consulting signals for axes and spindles.
TANGACT(axis)
The CNC sets this mark high (=1) to indicate that tangential control is active in the axis. The
CNC sets this mark high (=0) when freezing (suspending) or canceling the tangential control
of the axis.
LOPEN(axis)
The CNC activates this mark to inform the PLC that the axis position loop is open.
MAXDIFF(axis)
This mark is used on gantry axes. The CNC activates this mark when it cannot correct the
position difference between the master axis and the slave axis because the difference is
greater than the value set in machine parameter MAXDIFF. Position correction must be
enabled in machine parameter DIFFCOMP.
To Next Page
Loading...
