Fagor CNC 8065 - Page 423

Installation manual
CNC 8060
CNC 8065
TOOL AND MAGAZINE MANAGEMENT.
7.
(REF: 1402)
·423·
Asynchronous magazine with changer arm.
Treatment of the M106 function:
• Completed when the changer arm exits the collision zone and machining is possible.
• Activate the CH2TOMZ mark when the tool has been left to let the tool manager know
that the tool has been taken from holder 2 to the magazine".
Certain operations require using the information transferred by the tool manager in the
following registers:
Manager emergency signal.
Treatment of the tool manager emergency signal.
DFU B11KEYBD1 AND NOT TMINEM = SET SETTMEM
DFU TMINEM = RES SETTMEM
Pressing the USER12 key activates the emergency.
TMINEM = B11KEYLED1
The lamp of the USER12 key turns on when there is an emergency.
TMINEM AND DFU B12KEYBD1 = SET RESTMEM
Pressing the USER13 key removes the emergency.
LEAVEPOS This register indicates the magazine position to leave the tool.
TAKEPOS This register indicates the magazine position of the tool to be taken.