·426·
Installation manual
CNC 8060
CNC 8065
8.
KEY CODES.
(REF: 1402)
Keystroke combination.
To simulate from a keystroke combination from the PLC, for example [CTRL]+[F1], proceed
as follows.
1 [CTRL] key. Send the code for pressing the key.
2 [F1] key. Send the code for pressing the key.
3 [CTRL] key. Send the code for releasing the key.
4 [F1] key. Send the code for releasing the key.
When sending the key pressing code and the key releasing codes, it is recommended to use
a delay between them (for safety).
CNC's own keys.
The [START], [STOP] and [RESET] keys may be actuated from the PLC using the CYSTART,
_STOP and RESETIN keys respectively. The rest of the CNC's own keys, such as the ones
for accessing work modes, may be simulated through their hotkeys.
Hotkey. Work mode.
[CTRL] + [A] Task window.
[CTRL] + [SHIFT] + [F1] Main menu.
[CTRL] + [F6] Automatic mode.
[CTRL] + [F7] Jog mode.
[CTRL] + [F8] MDI mode.
[CTRL] + [F9] EDISIMU mode.
[CTRL] + [F10] User tables.
[CTRL] + [F11] Tool and magazine table.
[CTRL] + [F12] Utilities mode.
[SHIFT] + [F1] User mode.
Hotkey. Using the screens.
[CTRL] + [F1] Previous horizontal menu.
[CTRL] + [F2] Window change.
[CTRL] + [F3] Screen change.
Hotkey. Operations at the CNC.
[ALT] + [B] Two-color key.
[CTRL] + [F4] HELP.
[CTRL] + [F5] RECALL.
[CTRL] + [B] "Single block" mode.
Home search.
[CTRL] + [J] Show/Hide virtual operator panel.
To Next Page
Loading...
