Fagor CNC 8065 - Page 442

·442·
Installation manual
CNC 8060
CNC 8065
9.
CONCEPTS.
(REF: 1402)
Configure the name and number of axes and spindles.
LATHE WITH 1 CHANNEL, 3 AXES AND 1 SPINDLE.
CONFIGURATION OF TRIHEDRON TYPE AXES.
The axes and spindles are distributed as follows.
General configuration of the channels, axes and spindles.
Configuration of the axes and spindles of the system.
Configuration of the axes and spindles of channel ·1·.
Plane selection in channel ·1·.
With a trihedron-type-axis configuration, the planes behave in the same way as on a milling
machine except that the usual work plane will be G18 (if it has been configured like that in
parameter IPLANE).
Channel ·1·. 3 axes (X Y Z) 1 spindle (S).
System Channel ·1·
NCHANNEL = 1 GEOCONFIG = Trihedron
NAXIS = 3 CHNAXIS = 3
NSPDL = 1 CHNSPDL = 1
AXISNAME Value Logic order. Index in the system.
AXISNAME 1 X Logic number ·1·.
AXISNAME 2 Y Logic number ·2·.
AXISNAME 3 Z Logic number ·3·.
SPDLNAME 1 S Logic number ·4·. Spindle with index ·1·.
CHAXISNAME Value Index in the channel. Logic order.
CHAXISNAME 1 X Axis with index ·1·. Logic number ·1·.
CHAXISNAME 2 Y Axis with index ·2·. Logic number ·2·.
CHAXISNAME 3 Z Axis with index ·3·. Logic number ·3·.
CHSPDLNAME Value Index in the channel. Logic order.
CHSPDLNAME 1 S Spindle with index ·1·. Logic number ·4·.
Function. Selected plane.
G17 X-Y plane. Perpendicular axis Z.
G18 Z-X plane. Perpendicular axis Y.
G19 Y-Z plane. Perpendicular axis X.
G20 Any plane and/or longitudinal axis.