·46·
Installation manual
CNC 8060
CNC 8065
2.
MACHINE PARAMETERS.
(REF: 1402)
Parameters to verify before the startup.
MAXFEED Maximum machining feedrate.
This parameter should be set to a value other than ·0·.
FLWEMONITOR Type of monitoring of the following error (axis lag).
Monitoring must be activated.
MINFLWE This parameter indicates the maximum amount of following error allowed
when the axis is stopped.
MAXFLWE For standard monitoring of the following error, this parameter indicates the
maximum amount of following error allowed when the axis is moving.
For "linear" monitoring of the following error, this parameter indicates the
value starting at which the following error will be dynamically monitored.
FEDYNFAC For "linear" monitoring of the following error, this parameter indicates the
percentage error, deviation of the real following error value with respect to
the theoretical value.
Parameter Meaning
To Next Page
Loading...
