·480·
Installation manual
CNC 8060
CNC 8065
9.
CONCEPTS.
(REF: 1402)
Software limits of the axes.
Second software travel limits.
These software travel limits are set with the following variables that can be written via part-
program, MDI, PLC or interface. These variables are initialized on power-up assuming the
maximum value possible. When modifying the limits with these variables, the CNC assumes
those values as the new limits in this group.
Setting both upper and lower limits of an axis to ·0· cancels the limits and the CNC applies
the first software travel limits to the axis.
Variable. Meaning.
(V.)[ch].A.RTNEGLIMIT.xn Lower software travel limits (second limits).
(V.)[ch].A.RTPOSLIMIT.xn Upper software travel limits (second limits).
To Next Page
Loading...
