Fagor CNC 8065 - Page 511

Installation manual
CNC 8060
CNC 8065
CONCEPTS.
9.
(REF: 1402)
·511·
Calculation of the kinematics dimensions.
Origin preset on the X axis.
1 Keep previous position, A=90º and B=-90º.
2 Probe on the table, in the direction of the X axis.
3 Jot down the position value (coordinate) shown at the CNC, appearing in the drawing as
ΔX.
4 Preset X = -r so X=0 coincides with the surface of the table.
Calculation of the rest of the parameters.
The drawing shows two different positions of the B axis while keeping the position of the A
axis.
First position.
1 Position rotary axes A and B at 0º.
2 Make a probing movement along the X axis at point 1. Jot down the position value
(coordinate) shown at the CNC, appearing in the drawing as ΔX1.
3 Make a probing movement along the Z axis at point 2. Jot down the position value
(coordinate) shown at the CNC, appearing in the drawing as ΔZ.
4 Preset Z=0.
Second position.
1 Position the A rotary axis at 0º and the B axis at -90º.
2 Make a probing movement along the Z axis at point 3. Jot down the position value
(coordinate) shown at the CNC, appearing in the drawing as ΔZ1.
A=90º
B=-90º
r
Z
X
ΔX
Z
X
A=0º
B=-90º
A=0º
B=0º
Δ
X+r
Δ
Z
1
2
3
ΔZ
1
TDATA2
ΔX
1
TDATA5
P
Z
TDATA4
F
E
E
r