·516·
Installation manual
CNC 8060
CNC 8065
9.
CONCEPTS.
(REF: 1402)
Management of several keyboards.
Manage the LED's (lamps) of the keys.
Registers KEYLED1 and KEYLED2 control the LED's (lamps) of the keys of all the operator
panels at the same time.
Registers KEYLED1_n and KEYLED2_n control the LED's (lamps) of the keys of each
operator panel. Registers KEYLED1_1 and KEYLED2_1 correspond to the first jog panel,
KEYLED1_2 and KEYLED2_2 to the second one and so on.
Change the default behavior of the keyboards with respect to
the channels.
These registers may be used to change the default behavior of the keyboards with respect
to the channels, set by machine parameters. These registers can associate a jog panel with
a particular channel, always with the active channel or restore the configuration defined in
the machine parameters.
Disable the jog panels.
If the PLC activates one of these marks the CNC disables the corresponding jog panel. Each
mark may be used to disable the jog panel integrated into the CAN bus; the rest of the
elements of the bus are not affected. When the keyboard and the operator panel make up
a single element, this mark only disables the jog panel.
There is one mark for each keyboard or jog panel. The PANELOFF1 mark disables the first
one of the bus, the PANELOFF2 mark the second one and so on. Both PANELOFF and
PANELOFF1 are valid for the first jog panel.
PLC marks and registers. Meaning.
KEYLED1 / KEYLED2 These registers control the LED's (lamps) of the keys of all the
operator panels at the same time.
KEYLED1_1 / KEYLED2_1
··
KEYLED1_8 / KEYLED2_8
These registers control the LED's (lamps) of the keys of each
operator panel.
PLC marks and registers. Meaning.
KEYBD1CH to KEYBD8CH These registers may be used to change the default behavior of the
keyboards with respect to the channels, set by machine parameters.
Value. Meaning.
0 Configuration defined in the machine parameters.
1 Jog panel assigned to channel 1.
2 Jog panel assigned to channel 2.
3 Jog panel assigned to channel 3.
4 Jog panel assigned to channel 4.
FF Jog panel assigned to the active channel.
PLC marks and registers. Meaning.
PAN EL OFF
PANELOFF1 to PANELOFF8
If the PLC sets this one of these marks high (=1) the CNC disables
the corresponding jog panel.
Address Element PLC mark
0CNC
1 Remote (I/O) group
2 Jog panel PANELOFF1
To Next Page
Loading...
