Fagor CNC 8065 - Page 547

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·547·
Variables related to general machine parameters.
(V.)MPG.REFNEED[tbl]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cross compensation table [tbl]. Both axes must be homed in order to apply the
compensation.
Syntax.
·tbl· Table number.
Values of the variable.
This variable returns one of the following values.
(V.)MPG.POSITION[tbl][pt]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cross compensation table [tbl]; point [pt] Position of the master axis.
Syntax.
·tbl· Table number.
·pt· Point in the table.
(V.)MPG.POSERROR[tbl][pt]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cross compensation table [tbl]; point [pt] Amount of error to compensate when moving in
the positive direction.
If there is no bi-directional, it indicates the amount of error to compensate in both directions.
Syntax.
·tbl· Table number.
·pt· Point in the table.
(V.)MPG.NEGERROR[tbl][pt]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Cross compensation table [tbl]; point [pt] Amount of error to compensate when moving in
the negative direction.
Syntax.
·tbl· Table number.
·pt· Point in the table.
V.MPG.REFNEED[3] Third cross compensation table.
Value. Meaning.
0No.
1Yes.
V.MPG.POSITION[3][14] Point 14 of the third cross compensation table.
V.MPG.POSERROR[3][14] Point 14 of the third cross compensation table.
V.MPG.NEGERROR[3][14] Point 14 of the third cross compensation table.