Fagor CNC 8065 - Page 559

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·559·
Variables related to the machine parameters of the channels.
Remarks.
CONFIGURING THE SPINDLES OF THE CHANNEL.
(V.)[ch].MPG.CHNSPDL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Number of spindles of the channel.
It is possible to change the configuration of the spindles of a channel via part-program,
(defining a new configuration, adding or remove spindles) using the instructions #SET SP,
#FREE SP and #CALL SP.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.CHSPDLNAMEn
Variable to be read via interface.
Channel [ch]. Name the "n" spindle of the channel.
Syntax.
·ch· Channel number.
·n· Index of the spindle in the channel.
CONFIGURATION OF THE C AXIS.
(V.)[ch].MPG.CAXNAME
Variable to be read via interface.
Channel [ch]. Name of the axis working as "C" axis (by default).
When setting more than one C axis, use the program instruction #CAX to indicate the one
that is active. Only one C axis may be active in each channel.
Configuration. Configuration properties.
"Trihedron" type. In this configuration, there are three axes forming a Cartesian XYZ type
trihedron like on a milling machine. There may be more axes besides those
forming the trihedron.
With this configuration, the planes behave in the same way as on a milling
machine except that the usual work plane will be G18 (if it has been
configured like that).
"plane" type. In this configuration, there are two axes forming the usual work plane. There
may be more axes, but they cannot be part of the trihedron; there must be
auxiliary, rotary, etc.
With this configuration, the work plane is always G18 and will be formed by
the first two axes defined in the channel. In this configuration, the second axis
of the channel is considered as longitudinal axis.
If the X (first) and Z (second) axes have been defined, the work plane will be
the ZX (Z as abscissa and X as ordinate) and Z the longitudinal axis.
Tool length compensation is applied on this longitudinal axis when using
milling tools. With lathe tools, tool length compensation is applied on all the
axes where a tool offset has been defined.
V.[2].MPG.CHSPDL Channel ·2·.
[2].MPG.CHSPDLNAME1 Spindle with index ·1· in the channel ·2·.