Fagor CNC 8065 - Page 562

·562·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the machine parameters of the channels.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.MINCORFEED
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Minimum feedrate at the corners.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.FSMOOTHFREQ
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Smoothing frequency in the interpolation (FAST mode).
Syntax.
·ch· Channel number.
(V.)[ch].MPG.FASTFILTFREQ
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Filter frequency (FAST mode).
Syntax.
·ch· Channel number.
(V.)[ch].MPG.FREQRES
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. First resonance frequency of the machine.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.SOFTFREQ
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Path filter frequency for profiles of linear acceleration.
Syntax.
·ch· Channel number.
V.[2].MPG.FTIMELIM Channel ·2·.
V.[2].MPG.MINCORFEED Channel ·2·.
V.[2].MPG.FSMOOTHFREQ Channel ·2·.
V.[2].MPG.FASTFILTFREQ Channel ·2·.
V.[2].MPG.FREQRES Channel ·2·.
V.[2].MPG.SOFTFREQ Channel ·2·.