Fagor CNC 8065 - Page 568

·568·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the machine parameters of the channels.
(V.)[ch].MPG.LCOMPTYP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Keep the longitudinal axis when changing planes (G17/G18/G19).
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPG.ICORNER
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Default type of corner (G5/G7/G50).
The channel assumes the default value on power-up, after executing an M02 or M30 or after
a Reset. To change the type of corner via part-program, use function G5, G7 or G50.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPG.IRCOMP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Tool radius compensation mode (G136/G137) by default
The channel assumes the default value on power-up, after executing an M02 or M30 or after
a Reset. To change the type of tool radius compensation via part-program, use function G136
or G137.
Syntax.
·ch· Channel number.
V.[2].MPG.LCOMPTYP Channel ·2·.
Value. Meaning.
0No.
1Yes.
V.[2].MPG.ICORNER Channel ·2·.
Value. Meaning.
0 G50.
1 G05.
2 G07.
V.[2].MPG.IRCOMP Channel ·2·.