Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·577·
Variables related to the machine parameters of the channels.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPG.FRAPIDEN
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Rapid traverse in the channel when rapid traverse for the automatic mode is
active (parameter RAPIDEN). If the parameter is set with a "0" value, the feedrate is not
limited.
This parameter does not the movements programmed in G00 or the threads. Movements
in G0 are carried out at the feedrate set in parameter G00FEED. The threads are executed
at the programmed feedrate.
Syntax.
·ch· Channel number.
Remarks.
Rapid traverse cannot exceed the value set in axis parameters G00FEED and FRAPIDEN
or the maximum feedrate set by PLC (variable (V.)PLC.G00FEED). Rapid traverse cannot
exceed the value set in axis parameter MAXFEED of the channel and the active feedrate
set by PLC (variable (V.)PLC.F).
MAXIMUM ACCELERATION AND JERK ON THE TOOL PATH.
(V.)[ch].MPG.MAXACCEL
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Maximum acceleration on the machining path.
Syntax.
·ch· Channel number.
(V.)[ch].MPG.MAXJERK
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Maximum jerk on the machining path.
Syntax.
·ch· Channel number.
Value. Meaning.
0 Disabled. Rapid traverse is not available for the automatic mode.
1 EXRAPID or rapid key.
To activate the rapid feed, just activate the PLC mark EXRAPID or press the "rapid"
key of the jog panel.
2 EXRAPID and rapid key.
To activate the rapid feed, just activate the PLC mark EXRAPID and press the "rapid"
key of the jog panel.
V.[2].MPG.FRAPIDEN Channel ·2·.
V.[2].MPG.MAXACCEL Channel ·2·.
V.[2].MPG.MAXJERK Channel ·2·.
To Next Page
Loading...
