Installation manual
CNC 8060
CNC 8065
MACHINE PARAMETERS.
2.
(REF: 1402)
·59·
General machine parameters.
CANLENGTH
CANfagor bus cable length.
Possible values: Up to 20, 30, 40, 50, 60, 70, 80, 90, 100, 110, 120, 130 and more than 130 meters.
Default value: Up to 20 meters.
Associated variable: (V.)MPG.CANLENGTH
The work speeds at the bus depend on the total length of the bus.
SERIAL LINE CONFIGURATION.
RSTYPE
Type of serial line.
Possible values: RS232 / RS485 / RS422.
Default value: RS232.
Associated variable: (V.)MPG.RSTYPE
Type of serial line. For the HBLS (portable operator panel) select RS422.
Standard configuration for RS232 and full-duplex configuration for RS422.
DEFAULT CONDITIONS (SYTEM).
INCHES
Default work units (millimeters, inch).
Possible values: Millimeters / inches.
Default value: Millimeters.
Associated variable: (V.)MPG.INCHES
This parameter indicates the work units assumed by the CNC by default; i.e. on power-up,
after executing an M02 or M30 or after a reset. To change the units from the part-program,
use function G70 or G71.
ARITHMETIC PARAMETERS.
MAXLOCP
Maximum local arithmetic parameter.
Possible values: From 0 to 99.
Default value: 25.
Associated variable: (V.)MPG.MAXLOCP
See general machine parameter MINLOCP.
Length (m)
20 30 40 50 60 70 80 90 100 110 120 130 >130
Speed (KHz)
1000 888 800 727 666 615 571 533 500 480 430 400 250
In the RS485, the CNC uses the same signal to control "send data" and "receive data", therefore
sending is disabled while receiving. In order to ensure proper communication, an 8-ms delay is required
from when the CNC stops sending till it is ready to receive data. At the slaves connected to the CNC,
this delay time must be set from when data is received till it is sent. An external RS232/RS485 adapter
should be used if this delay cannot be set at the slave.
To Next Page
Loading...
