·590·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to axis and spindle machine parameters.
Values of the variable.
This variable returns one of the following values.
CONFIGURATION OF THE SPINDLE.
(V.)[ch].MPA.AUTOGEAR.sn
(V.)[ch].SP.AUTOGEAR.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Automatic gear change.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
Values of the variable.
This variable returns one of the following values.
(V.)[ch].MPA.LOSPDLIM.sn
(V.)[ch].SP.LOSPDLIM.sn
Variable that can only be read from the program, PLC and interface.
Variable valid for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Channel [ch]. Lower "rpm OK" percentage.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
Value. Meaning.
0No.
1Yes.
V.MPA.AUTOGEAR.S Spindle S.
V.SP.AUTOGEAR.S Spindle S.
V.SP.AUTOGEAR Master spindle.
V.MPA.AUTOGEAR.4 Spindle with logic number ·4·.
V.SP.AUTOGEAR.2 Spindle with index ·2· in the system.
V.[2].SP.AUTOGEAR.1 Spindle with index ·1· in the channel ·2·.
Value. Meaning.
0No.
1Yes.
V.MPA .LOSPDLIM.S Spindle S.
V.SP.LOSPDLIM.S Spindle S.
V.SP.LOSPDLIM Master spindle.
V.MPA .LOSPDLIM.4 Spindle with logic number ·4·.
V.SP.LOSPDLIM.2 Spindle with index ·2· in the system.
V.[2].SP.LOSPDLIM.1 Spindle with index ·1· in the channel ·2·.
To Next Page
Loading...
