Fagor CNC 8065 - Page 629

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·629·
Variables related to the sets of machine parameters.
(V.)[ch].MPA.MAXFREQ[set].sn
(V.)[ch].SP.MAXFREQ[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified from the environment of the oscilloscope and setup.
Variable valid for spindles.
Variable valid for Mechatrolink drive.
The variable returns the execution value; reading it interrupts block preparation.
This is the frequency the CNC must provide for the spindle to reach the maximum speed set
by parameter G00FEED.
Syntax.
·ch· Channel number.
·set· Parameter set.
·sn· Name, logic number or index of the spindle.
(V.)[ch].MPA.MAXRPM[set].xn
(V.)[ch].MPA.MAXRPM[set].sn
(V.)[ch].SP.MAXRPM[set].sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for Mechatrolink drive.
The variable returns the execution value; reading it interrupts block preparation.
Maximum motor rpm.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
RAPID TRAVERSE FOR THE AUTOMATIC MODE.
(V.)[ch].MPA.FRAPIDEN[set].xn
(V.)[ch].MPA.FRAPIDEN[set].sn
(V.)[ch].SP.FRAPIDEN[set].sn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the value of block preparation.
Rapid traverse of the axis when the rapid traverse for the automatic mode is active (parameter
RAPIDEN). If the parameter is set with a "0" value, the feedrate is not limited.
V.MPA.MAXFREQ[3].S Spindle S.
V.SP.MAXFREQ[3].S Spindle S.
V.SP.MAXFREQ[3] Master spindle.
V.MPA.MAXFREQ[3].4 Spindle with logic number ·4·.
V.SP.MAXFREQ[3].2 Spindle with index ·2· in the system.
V.[2].SP.MAXFREQ[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA.MAXRPM[3].Z Z axis.
V.MPA.MAXRPM[3].S Spindle S.
V.SP.MAXRPM[3].S Spindle S.
V.SP.MAXRPM[3] Master spindle.
V.MPA.MAXRPM[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.MAXRPM[3].1 Axis with index ·1· in the channel ·2·.
V.SP.MAXRPM[3].2 Spindle with index ·2· in the system.
V.[2].SP.MAXRPM[3].1 Spindle with index ·1· in the channel ·2·.