Fagor CNC 8065 - Page 652

·652·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to the sets of machine parameters.
With "standard" monitoring, this variable indicates the maximum amount of following error
allowed when the axis is moving; with "linear" monitoring, it indicates when dynamic
supervision begins (starting at which amount of following error).
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
(V.)[ch].MPA.FEDYNFAC[set].xn
(V.)[ch].MPA.FEDYNFAC[set].sn
(V.)[ch].SP.FEDYNFAC[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified during setup.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the execution value; reading it interrupts block preparation.
Percentage of following error deviation allowed.
Syntax.
·ch· Channel number.
·set· Parameter set.
·xn· Name, logic number or index of the axis.
·sn· Name, logic number or index of the spindle.
(V.)[ch].MPA.ESTDELAY[set].xn
(V.)[ch].MPA.ESTDELAY[set].sn
(V.)[ch].SP.ESTDELAY[set].sn
Variable that can only be read from the program, PLC and interface.
Variable that may be modified from the environment of the oscilloscope and setup.
Variable valid for rotary and linear axes as well as for spindles.
Variable valid for analog drive, position Sercos and velocity Sercos.
The variable returns the execution value; reading it interrupts block preparation.
Following error delay.
Syntax.
·ch· Channel number.
·set· Parameter set.
V.MPA.MAXFLWE[3].Z Z axis.
V.MPA.MAXFLWE[3].S Spindle S.
V.SP.MAXFLWE[3].S Spindle S.
V.SP.MAXFLWE[3] Master spindle.
V.MPA.MAXFLWE[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.MAXFLWE[3].1 Axis with index ·1· in the channel ·2·.
V.SP.MAXFLWE[3].2 Spindle with index ·2· in the system.
V.[2].SP.MAXFLWE[3].1 Spindle with index ·1· in the channel ·2·.
V.MPA .FEDYNFAC[3].Z Z axis.
V.MPA .FEDYNFAC[3].S Spindle S.
V.SP.FEDYNFAC[3].S Spindle S.
V.SP.FEDYNFAC[3] Master spindle.
V.MPA .FEDYNFAC[3].4 Axis or spindle with logic number ·4·.
V.[2].MPA.FEDYNFAC[3].1 Axis with index ·1· in the channel ·2·.
V.SP.FEDYNFAC[3].2 Spindle with index ·2· in the system.
V.[2].SP.FEDYNFAC[3].1 Spindle with index ·1· in the channel ·2·.