Fagor CNC 8065 - Page 707

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·707·
PLC consulting logic signals; spindles.
(V.)PLC.SYNCSPEED
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The slave spindle activates this mark when it is synchronized in velocity.
(V.)PLC.SYNCPOSI
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The slave spindle activates this mark when it is synchronized in position.
(V.)PLC.GEAROK
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The spindle activates this mark when the parameter set selected at the CNC and at the PLC
are the same.
V.PLC.SYNCSPEED1 Spindle ·1·.
V.PLC.SYNCSPEED2 Spindle ·2·.
V.PLC.SYNCSPEED3 Spindle ·3·.
V.PLC.SYNCSPEED4 Spindle ·4·.
V.PLC.SYNCPOSI1 Spindle ·1·.
V.PLC.SYNCPOSI2 Spindle ·2·.
V.PLC.SYNCPOSI3 Spindle ·3·.
V.PLC.SYNCPOSI4 Spindle ·4·.
V.PLC.GEAROK Spindle ·1·.
V.PLC.GEAROK1 Spindle ·1·.
V.PLC.GEAROK2 Spindle ·2·.
V.PLC.GEAROK3 Spindle ·3·.
V.PLC.GEAROK4 Spindle ·4·.