Fagor CNC 8065 - Page 717

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·717·
PLC modifiable logic signals; general.
(V.)PLC.TIMERON
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the CNC enables the freely available clock.
(V.)PLC.PLCREADY
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark off, it interrupts the execution of the PLC program and issues an
error message.
(V.)PLC.NOWAIT
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC turns this mark on to cancel the channel synchronizations programmed with #WAIT.
(V.)PLC.DISCROSS1
(V.)PLC.DISCROSS2
(V.)PLC.DISCROSS3
(V.)PLC.DISCROSS4
(V.)PLC.DISCROSS5
(V.)PLC.DISCROSS6
(V.)PLC.DISCROSS7
(V.)PLC.DISCROSS8
(V.)PLC.DISCROSS9
Variable that can only be read from the program and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC this mark on to disable the cross compensation table.
(V.)PLC.PLCABORT
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the channel aborts the CNCEX command launched from the
PLC. This mark does not set the initial conditions in the channel and keeps the history.
V.PLC.TIMERON
V.PLC.PLCREADY
V.PLC.NOWAITC1 Channel ·1·.
V.PLC.NOWAITC2 Channel ·2·.
V.PLC.NOWAITC3 Channel ·3·.
V.PLC.NOWAITC4 Channel ·4·.
V.PLC.DISCROSS1 Cross compensation table ·1·.
V.PLC.DISCROSS2 Cross compensation table ·2·.
V.PLC.PLCABORT Channel ·1·.
V.PLC.PLCABORTC1 Channel ·1·.
V.PLC.PLCABORTC2 Channel ·2·.
V.PLC.PLCABORTC3 Channel ·3·.
V.PLC.PLCABORTC4 Channel ·4·.