Fagor CNC 8065 - Page 719

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·719·
PLC modifiable logic signals; general.
(V.)PLC.PRGABORT
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the channel aborts the execution of the program but without
affecting the spindle, initializes the program history and resumes the execution in the point
indicated by the #ABORT instruction active in the part-program.
(V.)PLC.CNCOFF
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns this mark on, the CNC starts the shut-down sequence.
(V.)PLC.INHIBITMPG1
···
(V.)PLC.INHIBITMPG12
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC turns one of these marks on, it disables the corresponding handwheel. The PLC
has a mark for each handwheel, the INHIBITMPG1 mark disables the first handwheel, the
INHIBITMPG2 mark the second one and so on.
(V.)PLC.EXRAPID
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
If the PLC activates this mark, the CNC channel enables rapid traverse during the execution
of a program for the programmed movements. The behavior of this mark depends on how
parameter RAPIDEN has been set.
(V.)PLC.KEYBD1CH
··
(V.)PLC.KEYBD8CH
Variable that can be read and written from the interface and read from the program.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
These registers may be used to change the default behavior of the keyboards with respect
to the channels, set by machine parameters.
V.PLC.PRGABORT Channel ·1·.
V.PLC.PRGABORTC1 Channel ·1·.
V.PLC.PRGABORTC2 Channel ·2·.
V.PLC.PRGABORTC3 Channel ·3·.
V.PLC.PRGABORTC4 Channel ·4·.
V.PLC.CNCOFF
V.PLC.INHIBITMPG1 Handwheel ·1·.
V.PLC.INHIBITMPG2 Handwheel ·2·.
V.PLC.EXRAPIDC1 Channel ·1·.
V.PLC.EXRAPIDC2 Channel ·2·.
V.PLC.EXRAPIDC3 Channel ·3·.
V.PLC.EXRAPIDC4 Channel ·4·.
V.PLC.KEYBD1CH Operator panel ·1·.
V.PLC.KEYBD2CH Operator panel ·2·.