Fagor CNC 8065 - Page 724

·724·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
PLC modifiable logic signals; axes and spindles.
(V.)PLC.SERVOxnON
(V.)PLC.SERVOsnON
Variable that can be read and written from the interface and read from the program and from the PLC.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on to allow moving the axis or the spindle.
Syntax.
·xn· Name or logic number of the axis.
·sn· Name or logic number of the spindle.
(V.)PLC.DROxn
(V.)PLC.DROsn
Variable that can be read and written from the interface and read from the program and from the PLC.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on for the axis or the spindle to work in DRO mode.
Syntax.
·xn· Name or logic number of the axis.
·sn· Name or logic number of the spindle.
(V.)PLC.SPENAxn
(V.)PLC.SPENAsn
Variable that can be read and written from the interface and read from the program and from the PLC.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on to enable the speed enable signal of the drive.
Syntax.
·xn· Name or logic number of the axis.
·sn· Name or logic number of the spindle.
(V.)PLC.DRENAxn
(V.)PLC.DRENAsn
Variable that can be read and written from the interface and read from the program and from the PLC.
Variable valid for rotary and linear axes as well as for spindles.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
The PLC must turn this mark on to enable the drive enable signal of the drive.
Syntax.
·xn· Name or logic number of the axis.
V.PLC.SERVOXON X axis.
V.PLC.SERVOSON Spindle S.
V.PLC.SERVO3ON Axis or spindle with logic number ·3·.
V.PLC.DROX X axis.
V.PLC.DROS Spindle S.
V.PLC.DRO3 Axis or spindle with logic number ·3·.
V.PLC.SPENAX X axis.
V.PLC.SPENAS Spindle S.
V.PLC.SPENA3 Axis or spindle with logic number ·3·.