Fagor CNC 8065 - Page 741

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·741·
Variables related to the machine configuration.
Values of the variable.
The values returned by this variable are encoded as follows.
(V.)[ch].G.MASTERSP
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Logic number of the master spindle of the channel.
Syntax.
·ch· Channel number.
TRAVEL LIMITS OF LINEAR AND ROTARY AXES.
(V.)[ch].G.SOFTLIMIT
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Software limits reached.
Syntax.
·ch· Channel number.
(V.)[ch].A.POSLIMIT.xn
(V.)[ch].A.NEGLIMIT.xn
Variable that can be read and written from the program and read from the PLC and from the interface.
Variable valid for rotary and linear axes.
The variable returns the value of block preparation.
Positive and negative software limit.
Syntax.
·ch· Channel number.
·xn· Name, logic number or index of the axis.
Remarks.
These variables correspond to the limits set by machine parameters. When modifying these
variables, the CNC assumes those values as the new limits from then on.
These variables keep their value after a Reset, they are initialized with the values of the
machine parameters when validating them and when turning the CNC on.
(V.)[ch].A.RTPOSLIMIT.xn
(V.)[ch].A.RTNEGLIMIT.xn
Variable that can be read and written via program, PLC and interface.
Variable valid for rotary and linear axes.
The variable returns the execution value; reading it interrupts block preparation.
Second positive and negative software limit.
S=100 S1=101 S2=102 S3=103 S4=104 ... S9=109
V.[2].G.MASTERSP Channel ·2·.
V.[2].G.SOFTLIMIT Channel ·2·.
V.A.POSLIMIT.Z Z axis.
V.A.POSLIMIT.4 Axis with logic number ·4·.
V.[2].A.POSLIMIT.1 Axis with index ·1· in the channel ·2·.