Fagor CNC 8065 - Page 781

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·781·
Variables related to the position of the axes.
(V.)[ch].G.PLPPOS2
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes.
The variable returns the value of block preparation.
Channel [ch]. Coordinate programmed in the second axis of the channel (tool tip).
Syntax.
·ch· Channel number.
(V.)[ch].G.PLPPOS3
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes.
The variable returns the value of block preparation.
Channel [ch]. Coordinate programmed in the third axis of the channel (tool tip).
Syntax.
·ch· Channel number.
POSITION IN PART COORDINATES.
(V.)[ch].A.APOS.xn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Real part coordinates of the tool base.
Syntax.
·ch· Channel number.
·xn· Name, logic number or index of the axis.
(V.)[ch].A.ATPOS.xn
Variable that can only be read from the program, PLC and interface.
Variable valid for rotary and linear axes.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Theoretical part coordinates of the tool base.
Syntax.
·ch· Channel number.
·xn· Name, logic number or index of the axis.
V.[2].G.PLPPOS2 Channel ·2·.
V.[2].G.PLPPOS3 Channel ·2·.
V.A.APOS.Z Z axis.
V.A.APOS.3 Axis with logic number ·3·.
V.[2].A.APOS.3 Axis with index ·3· in the channel ·2·.
V.A.ATPOS.Z Z axis.
V.A.ATPOS.3 Axis with logic number ·3·.
V.[2].A.ATPOS.3 Axis with index ·3· in the channel ·2·.