Fagor CNC 8065 - Page 796

·796·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to managing the feedrate in HSC mode.
Values of the variable.
This variable returns one of the following values.
LIMITATION OF THE FEEDRATE AT THE CORNER.
(V.)[ch].G.AXLIMC
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Logic number of the axis that limits the feedrate at the corner, in the block being executed.
Together with the V.G.PARLIMC variable, it may be used to evaluate the behavior of the
machining operation at a particular corner where the feedrate decreases too much or is
irregular.
Syntax.
·ch· Channel number.
(V.)[ch].G.PARLIMC
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Cause that limits the feedrate at the corner in the block being executed.
Syntax.
·ch· Channel number.
Values of the variable.
This variable returns one of the following values.
Value. Meaning.
1 Maximum feedrate of the axis.
2 Acceleration due to curvature (parameter CURVACC).
3 Jerk due to curvature (parameter CURVJERK).
6 Error committed by the spline.
7 Insufficient memory due to very small blocks and/or buffer full.
10 Maximum axis feedrate in transformations.
11 Maximum axis acceleration in transformations.
V.[2].G.AXLIMC Channel ·2·.
V.[2].G.PARLIMC Channel ·2·.
Value. Meaning.
1 Maximum feedrate of the axis.
4 The acceleration at the corner (parameter CORNERACC).
5 The jerk at the corner (parameter CORNERJERK).
8 The chordal error at the corner ( CONTERROR).
9 Geometry at the corner (FAST mode).