·802·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to spindle speed.
(V.)[ch].PLC.SPOS.sn
Variable that can be read and written from the PLC and read from the program and from the interface.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Speed active by PLC for M19.
The speed programmed by PLC prevails over the one programmed by program or MDI. To
cancel the speed by PLC, set the variable to ·0·; the CNC applies the speed active by
program.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
(V.)[ch].A.PRGSPOS.sn
(V.)[ch].SP.PRGSPOS.sn
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Channel [ch]. Speed active by program for M19.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
SPEED LIMIT.
(V.)[ch].A.SLIMIT.sn
(V.)[ch].SP.SLIMIT.sn
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Channel [ch]. Active spindle speed limit.
Syntax.
·ch· Channel number.
·sn· Name, logic number or index of the spindle.
Remarks.
The maximum speed may be set by program or by PLC; the one set by PLC has the highest
priority.
V.PLC.SPOS.S2 Spindle S2.
V.PLC.SPOS.5 Spindle with logic number ·5·.
V.[2].PLC.SPOS.1 Spindle with index ·1· in the channel ·2·.
V.A.PRGSPOS.S Spindle S.
V.SP.PRGSPOS.S Spindle S.
V.SP.PRGSPOS Master spindle.
V.A.PRGSPOS.5 Spindle with logic number ·5·.
V.SP.PRGSPOS.2 Spindle with index ·2· in the system.
V.[2].SP.PRGSPOS.1 Spindle with index ·1· in the channel ·2·.
V.A.SLIMIT.S Spindle S.
V.SP.SLIMIT.S Spindle S.
V.SP.SLIMIT Master spindle.
V.A.SLIMIT.5 Spindle with logic number ·5·.
V.SP.SLIMIT.2 Spindle with index ·2· in the system.
V.[2].SP.SLIMIT.1 Spindle with index ·1· in the channel ·2·.
To Next Page
Loading...
