Fagor CNC 8065 - Page 843

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·843·
Variables related to jog mode.
Values of the variable.
This variable returns one of the following values.
SWITCH POSITION IN INCREMENTAL JOG MODE.
(V.)G.INCJOGIDX
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Active position for all the axes.
Values of the variable.
This variable returns one of the following values.
Remarks.
The value may be set by the switch of the operator panel or by PLC; the one set by PLC has
the highest priority.
(V.)G.CNCINCJOGIDX
Variable that can be read and written from the interface and read from the program and from the PLC.
The variable returns the execution value; reading it interrupts block preparation.
Report variable (to be used from the scripts).
Position selected by the switch.
The value set by the switch of the operator panel has lower priority than the one set by PLC.
Values of the variable.
This variable returns one of the following values.
Value. Meaning.
1 Position 1.
2 Position 10.
3 Position 100.
V.G.INCJOGIDX
Value. Meaning.
1 Position 1.
2 Position 10.
3 Position 100.
4 Position 1000.
5 Position 10000.
V.G.CNCINCJOGIDX
Value. Meaning.
1 Position 1.
2 Position 10.
3 Position 100.
4 Position 1000.
5 Position 10000.