Fagor CNC 8065 - Page 849

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·849·
Variables related to the programmed functions.
Syntax.
·ch· Channel number.
(V.)[ch].G.PLANELONG
Variable to be read via interface.
Index of the tool in the axis channel.
Syntax.
·ch· Channel number.
Remarks.
In this variable, the index in the channel of the first axis will be ·0·, that of the second axis
will be ·1· and so on.
"G" AND "M" FUNCTIONS.
(V.)[ch].G.GS[nb]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Report variable (to be used from the scripts).
Status of the requested "G" function.
Each function has a bit that indicates whether the relevant function is active (=1) or not (=0).
Syntax.
·ch· Channel number.
·nb· Function number.
(V.)[ch].G.MS[nb]
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Report variable (to be used from the scripts).
Status of the requested "M" function.
Each function has a bit that indicates whether the relevant function is active (=1) or not (=0).
Syntax.
·ch· Channel number.
·nb· Function number.
(V.)[ch].G.HGS1
(V.)[ch].G.HGS2
(V.)[ch].G.HGS3
(V.)[ch].G.HGS4
(V.)[ch].G.HGS5
(V.)[ch].G.HGS6
(V.)[ch].G.HGS7
[2].G.PLAXNAME1 Channel ·2·. Abscissa axis.
[2].G.PLAXNAME2 Channel ·2·. Ordinate axis.
[2].G.PLAXNAME3 Channel ·2·. Third main axis.
[2].G.PLANELONG Channel ·2·.
V.[2].G.GS[3] Channel ·2·. G3 function.
V.[2].G.MS[5] Channel ·2·. M5 function.