Fagor CNC 8065 - Page 851

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·851·
Variables related to the programmed functions.
(V.)[ch].G.HMS
Variable to be read via interface.
Report variable (to be used from the scripts).
"M" functions of the master spindle to be displayed in the history.
Remarks.
This variable returns a binary value. Each function has a bit that indicates whether the
relevant variable will be displayed (=1) or not (=0). Bit 0, the least significant bit, corresponds
to M0, bit 1 to M1 and so on.
(V.)[ch].G.HMS1
(V.)[ch].G.HMS2
(V.)[ch].G.HMS3
(V.)[ch].G.HMS4
Variable to be read via interface.
Report variable (to be used from the scripts).
"M" functions of spindle 1 through 4 to be displayed in the history.
Remarks.
This variable returns a binary value. Each function has a bit that indicates whether the
relevant variable will be displayed (=1) or not (=0). Bit 0, the least significant bit, corresponds
to M0, bit 1 to M1 and so on.
CANNED CYCLES.
(V.)[ch].G.CYCLETYPEON
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Type of canned cycle active
Syntax.
·ch· Channel number.
CANNED CYCLE CALLING PARAMETERS.
(V.)C.A··Z
Variable that can be read and written from the program.
The variable returns the value of block preparation.
Value of the ISO canned cycle calling parameter.
Syntax.
·A··Z· Call parameter.
[2].G.HMS Channel ·2·. Master spindle.
[2].G.HMS2 Channel ·2·. Spindle ·2·.
V.[2].G.CYCLETYPEON Channel ·2·.
V.C.F "F" parameter.