Fagor CNC 8065 - Page 865

Installation manual
CNC 8060
CNC 8065
CNC VARIABLES.
10.
(REF: 1402)
·865·
Variables related to the programmed functions.
·mk· Number of the synchronization mark.
(V.)[ch].G.WAITST[mk]
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
Status of the WAIT type mark [mk] in the [ch] channel.
Syntax.
·ch· Channel number.
·mk· Number of the synchronization mark.
(V.)[ch].G.MEETCH[nch]
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
MEET type mark originated in channel [nch] and expected by channel [ch].
Syntax.
·ch· Channel number.
·nch· Channel that originates the synchronization mark.
(V.)[ch].G.WAITCH[nch]
Variable that can only be read from the program, PLC and interface.
The variable returns the execution value; reading it interrupts block preparation.
WAIT type mark originated in channel [nch] and expected by channel [ch].
Syntax.
·ch· Channel number.
·nch· Channel that originates the synchronization mark.
SELECTION OF THE KINEMATICS.
(V.)[ch].G.KINID
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Number of the active kinematics.
If no kinematics is active, the variable will return a ·0· value.
Syntax.
·ch· Channel number.
V.[2].G.MEETST[4] Channel ·2·. Mark ·4·.
V.[2].G.WAITST[4] Channel ·2·. Mark ·4·.
V.[2].G.MEETCH[4] Channel ·2·. Channel ·4·.
V.[2].G.WAITCH[4] Channel ·2·. Channel ·4·.
V.[2].G.KINID Channel ·2·.