Fibocom L860-GL - Page 151

Reproduction forbidden without Fibocom Wireless Inc. written authorization – All Rights Reserved.
FIBOCOM L860 AT Commands User Manual Page 151 of 254
Command Description
Parameters <n>
0 Disables the network registration unsolicited result code.
1 Enables the network registration unsolicited result code +CGREG: <stat>.
2 Enables the network registration and location information in unsolicited result code
and Read command +CGREG: <stat>[,<lac>,<ci>].
3 Enable network registration, location information and GMM cause value information
unsolicited result code
+CGREG: <stat>[,[<lac>],[<ci>],[<AcT>],[<rac>][,<cause_type>,<reject_cause>]].
Note:
n=3 just supported by L810-GL-00,L830-EA-00,L830-GL-00.
The default value is 0.
<stat>
0 Not registered, and the ME is not currently searching for a new operator to register.
1 Registered, home network.
2 Not registered, but the ME is currently searching for a new operator to register.
3 Registration denied.
4 Unknown.
5 Registered, roaming.
6 registered for "SMS only",home network (not applicable)
7 registered for "SMS only", roaming (not applicable)
8 attached for emergency bearer services only (see Note 2) (applicable only when
<AcT> indicates 2,4,5,6).
Note:
3GPP TS 24.008 [8] and 3GPP TS 24.301 [83] specify the condition when
the MS is considered as attached for emergency bearer services.
<lac> string type; two byte location area code in hexadecimal format (e.g. "00C3"
equals 195 in decimal)
<ci> string type ; four byte GERAN/UTRAN cell ID in hexadecimal format
<AcT> It is a Release 7 feature and describes access technology of the registered
network. Possible values of <AcT> are:
0 GSM
1 GSM Compact