3-19
3.5 Drying system: what to do if. . .
The machine doesn’t dry well
1) The machine is switched off ⇒ Switch on the machine.
2) The machine doesn’t switch on ⇒ Refer to the proper section (see section
3.1 at page 8).
3) The vacuum motor is switched off ⇒ Switch on the vacuum motor.
4) The vacuum motor doesn’t switch
on
⇒ Refer to the proper section (see section
3.5 at page 15).
5) The machine is in ”ECO” mode ⇒ Set up the machine as per standard
configuration.
6) The squeegee is lifted up from the
floor
⇒ Lower down the squeegee.
7) The squeegee rubber blades are
worn out or broken
⇒ Rotate or replace the squeegee rub-
ber blades.
8) The recovery tank is full ⇒ Empty the recovery tank following
the proper procedure.
9) The squeegee is not properly ad-
justed
⇒ Adjust the squeegee properly follow-
ing the proper procedure (see section 7.3.1
at page 68).
10) The squeegee vacuum chamber is
stuck or dirty
⇒ Clean the squeegee vacuum cham-
ber.
11) The squeegee adapter is stuck or
dirty
⇒ Clean the squeegee adapter.
12) The vacuum hose is stuck or bro-
ken
⇒ Clean or replace the vacuum hose.
13) The vacuum hose is not properly
fitted in
⇒ Connect the vacuum hose properly.
14) The intake manifold is stuck or bro-
ken
⇒ Clean or replace the intake manifold.
15) The intake manifold is not properly
connected
⇒ Connect the intake manifold prop-
erly.
16) The vacuum filter is dirty or stuck ⇒ Disassemble and clean the vacuum
filter.
17) The vacuum cover is not well posi-
tioned or is missing
⇒ Position properly the vacuum cover.
18) The vacuum cover gasket doesn’t
adhere properly
⇒ Replace the vacuum cover gasket.
To Next Page
Loading...
