Operator‘s Manual FERITSCOPE
®
FMP30 Page 31
System Setup, Maintenance and Cleaning
The open Application is set to auto-averaging mode (
5.6.4 ‘Outlier rejection’, beginning on Page 50 and
7.3.7 ‘Measurements With Outlier Rejection Enabled’, be-
ginning on Page 93).
[i=]: Number of single readings measured using the auto-
averaging / set number of single readings to be combined
The open Application is set to the “free-running” display
mode:
( 7.7 ‘Measurements in the Free-Running Display
Mode’, beginning on Page 105)
The open Application is set to the “free-running” display
mode:
and analog display is enabled
( 7.7 ‘Measurements in the Free-Running Display
Mode’, beginning on Page 105 and 10.6.2 ‘Analog Dis-
play’, beginning on Page 168).
[10.00 11.00]: Limits of the analog display (example)
Matrix measuring mode is enabled:
( 7.8 ‘Measurements in Standard and Matrix Measur-
ing Mode’, beginning on Page 110 and 10.6.3 ‘Matrix
Mode’, beginning on Page 169).
Matrix measuring mode is enabled:
( 7.8 ‘Measurements in Standard and Matrix Measur-
ing Mode’, beginning on Page 110 and 10.6.3 ‘Matrix
Mode’, beginning on Page 169).
In addition, a designation each has been assigned to the
open Application (“sheet”) and to the current block (“back
side”) ( 5.5 ‘Assigning Application Designations’, begin-
ning on Page 44 and 7.8.5 ‘Assigning Block Designa-
tions’, beginning on Page 116).
Detail of the display Explanation of the displays after power up
To Next Page
Loading...