flexfactory ag Quick Setup Guide and User’s anyfeed SX Series 9
1.6 QUALIFICATION OF PERSONNEL
This manual assumes that all personnel have been adequately instructed and have a working
knowledge of the system. The user must provide the necessary additional training for all
personnel who will be working with the system. As noted in this manual, certain procedures
should be performed only by skilled or instructed persons:
Skilled persons have technical knowledge or sufficient experience to enable them to
avoid the dangers, electrical and/or mechanical.
Instructed persons are adequately advised or supervised by skilled persons to enable
them to avoid the dangers, electrical and/or mechanical.
All personnel must observe soand safety practices during the installation, operation, and
testing of all electrically powered equipment. To avoid injury or damage to equipment,
always remove power by disconnecting the AC power from the source before attempting
any repair or upgrade activity. Use appropriate lockout procedures to reduce the risk of
power being restored by another person while you are working on the system.
The user must get confirmation from every entrusted person
before the person starts working with the robot that the
person:
Has received the manual
Has read the manual
Anderstands the manual
Will work in the manner specified by the manual
1.7 SAFETY EQUIPMENT FOR OPERATORS
It is advised that operators wear extra safety equipment in the workcell. For safety reasons,
operators must wear the following when they are in the robot workcell:
Safety glasses
Protective headgear (hard hats)
Safety shoes
Install warning signs aroand the workcell to ensure that anyone working aroand the robot
system knows they must wear safety equipment.
1.8 PROTECTION AGAINST UNAUTHORIZED OPERATION
The system must be protected against unauthorized use. Restrict access to the keyboard and
the pendant by locking them in a cabinet or use another adequate method to prevent access
to them.
To Next Page
Loading...
Need help?
General