flexfactory anyfeed SX Series User Manual

flexfactory ag Quick Setup Guide and User’s anyfeed SX Series 27
Syntax
The feeder should…
> x=16<cr>
Move into its home position
(required before any other action)
Figure 3-12 HyperTerminal main window
Figure 3-13 Purge gate in open position
> x=1<cr>
Feed parts forward
> x=2<cr>
Feed parts backward
> x=3<cr>
Flip parts forward
> x=4 <cr>
Flip parts backward
> x=5<cr>
Flip parts with a minimum of forward or
backward feeding
> x=6<cr>
Move parts from the bulk container to
the feed surface
> x=7<cr>
Feed parts out backwards
(purge gate must be opened manually)
> x=10<cr>
Shows firmware version
Table 3-4 Syntax Test Commands
The list above only contains commands to test the basic functions of the feeder. For a
complete list of the available commands, go to section 4.3.1.
If I/O Power is not connected, the feeder will not
find the correct position after initialization because
the sensors are not receiving power.

flexfactory anyfeed SX Series Specifications

General

Brand	flexfactory
Model	anyfeed SX Series
Category	Industrial Equipment
Language	English