flexfactory ag Quick Setup Guide and User’s anyfeed SX Series 41
6 MAINTENANCE AND SETTINGS
6.1 PERIODIC MAINTENANCE
Clean upper side of feed surface and frame with a non-
abrasive, no-residue cleaner, such as rubbing alcohol or
window cleaner. Failure to do this may degrade vision
performance.
Feed Surface
Feed channel
Remove feed surface (as described in section 6.2) and
clean bottom side with a non-abrasive, no-residue cleaner,
such as rubbing alcohol or window cleaner. Clean support
surface and glass window with alcohol. Failure to do this
may degrade vision performance.
Remove side panel and clean upper side of backlight.
Failure to do this may degrade vision performance.
Check the two plastic silencers that are screwed into the
servo valve to see if they are blocked with oil. If needed,
replace the silencers. Failure to do this may degrade feeder
performance.
Table 6-1 Maintenance
6.2 REMOVING AND INSTALLING THE FEED SURFACE
The feed surface is subject to wear during normal system use and will need to be replaced
periodically. To replace the feed surface:
Follow proper lockout procedures before performing this
service procedure. Failure to do so could result in injury.
To Next Page
Loading...
Need help?
General