flexfactory anyfeed SX Series - List of Figures

flexfactory ag Quick Setup Guide and User’s anyfeed SX Series 3
LIST OF FIGURES
Figure 1-1 anyfeed SX 240 .......................................................................................................... 7
Figure 2-1 anyfeed SX parts ...................................................................................................... 12
Figure 2-2 Mounting rail screws ............................................................................................... 12
Figure 2-3 Handles for lifting and positioning .......................................................................... 13
Figure 2-4 anyfeed SX feeder ................................................................................................... 13
Figure 2-5 SX Servo Power Cable ............................................................................................. 14
Figure 2-6 SX Logic Power Cable .............................................................................................. 14
Figure 2-7 RS232 Cable ............................................................................................................. 14
Figure 3-1 SX 240 Dimensions .................................................................................................. 17
Figure 3-2 SX 160 Dimensions .................................................................................................. 18
Figure 3-3 Feeder on base plate ............................................................................................... 19
Figure 3-4 Connecting the pneumatic line ............................................................................... 20
Figure 3-5 anyfeed SX interface panel relevant connection points ......................................... 21
Figure 3-6 RS232 Cable ............................................................................................................. 23
Figure 3-7 Front Interface Panel LEDs ...................................................................................... 24
Figure 3-8 HyperTerminal connection settings ........................................................................ 25
Figure 3-9 HyperTerminal ASCII Setup ..................................................................................... 25
Figure 3-10 HT ASCII Setup ....................................................................................................... 25
Figure 3-11 HyperTerminal main window ................................................................................ 26
Figure 3-12 HyperTerminal main window ................................................................................ 27
Figure 3-13 Purge gate in open position .................................................................................. 27
Figure 5-1 Removing the Front Interface Panel ....................................................................... 36
Figure 5-2 Serial/parallel mode jumper ................................................................................... 37
Figure 5-3 Jumper settings ....................................................................................................... 37
Figure 5-4 Sticker ...................................................................................................................... 37
Figure 5-5 Parallel/serial switch ............................................................................................... 38
Figure 5-6 Signal handshake diagram ...................................................................................... 40